Home  |   New Vehicles  |   Used  |   Rentals  |   Photo Gallery  |   Parts/Accessories  |   Service/Repairs  |   About Us  |   Locations  |   Contact Us
 
EZ GO
Shuttle 2 Electric
 

 
Product Specification
 
Motor: 48 volt DC shunt wound, brazed armature, solid copper windings.
15.2 hp (11.3 kW) at 1600 RPM.
Drive Train:  Direct motor shaft connected to transaxle pinion shaft.
Electrical System: 48 volt DC, eight, 6 volt deep cycle storage batteries (115 minute minimum,225 amp-hour@ 20 Hr. discharge rate). Dash mounted direction selector switch (Forward – Neutral – Reverse)
Speed Control: Precision Drive System - Solid state continuously variable separately excited speed controller. 350 Amp capacity. Inductive throttle sensor
Precision Drive System: Anti-roll back, anti–stall, walk away, high pedal disable features. Run
Tow /
Maintenance switch. Diagnostic fault mode
Charger: Fully automatic line compensating, 21 amp DC output at 48 volts;
input 110-120 volts, 60 cycle AC
Transaxle: Differential with helical gears, 14.7:1 ratio.
Brakes: Dual rear wheel mechanical self-adjusting drum brakes. Automatic
park brake release with self-compensating system. Hydraulic front
disc brakes
Front Suspension: Leaf springs with hydraulic shock absorbers.
Rear Suspension: Leaf springs with hydraulic shock absorbers.
Steering: Self-compensating single reduction rack and pinion.
Speed: 13 mph ± 0.5 mph (21 kph ± 0.8 kph)
Weight: 810 lb (370 kg), (without batteries)
Ground Clearance: 4.25 in (10.8 cm) (at differential)
Length: 133 in (338 cm)
Width: 46.5 in (118 cm)
Height: 48.6 in (123 cm) (top of steering wheel)
Top Height: 73.0 in (185 cm)
Wheel Base: 93.5 in (237 cm)
Front Wheel Tread: 33.5 in (85 cm)
Rear Wheel Tread: 38.0 in (97 cm)
Cargo Bed: 44 in wide x 68.5 in long (112 cm W x 174 L cm)
Turning Circle Dia: 29 ft (8.8m)
Load Capacity: 1,200 lb (540 kg) including operator, passenger, accessories, and cargo
Seating: Vacuum formed fabric backed vinyl covers over cushion foam. Standard seating for operator and one passenger
Body: Front: Injection molded TPE (Thermoplastic Elastomer) Rear: Steel panels

 
Home  |  New Vehicles  |  Used   |  Rentals  |  Photo Gallery  |  Parts/Accessories  |  Service/Repairs  |  About Us  |  Locations  |  Contact Us
 

 

New Jersey

Brick Sales Office
P.O. Box 4292
Brick New Jersey 08723
732-551-0000

  
   

We Accept Visa, MasterCard,
American Express & Discover

   


Financing available for all
used and new golf carts

845-856-0611
 

 

New York

Tri-State Golf Carts
Po Box 4512/87 Neversink Drive
Port Jervis, New York 12771
845-856-06
11

Located at the Port Jervis Country Club

Site Hosted By Co-op Web Hosting
Designed by
Golf Cart Portal